← Back to the Kick card · All how-to pages
How to use
Kick
FREE · download it from its card
What it does
Kick is a hard techno kick drum: a sine wave whose pitch drops fast from high to low, with a click on top, drive and a tone filter. A separate low RUMBLE tail rings after each hit and ducks under the kick, for that rolling schranz low end.
It plays a hit on every trigger. The ENV output sends the kick's envelope as a voltage, so you can duck other sounds in time with it.
Quick start
- Patch a trigger or gate (from Euclid, MTX-1 or any clock) into TRIG.
- Patch KICK to your mixer or audio out. No sequencer handy? Right-click the panel and pick Trigger kick (audition) to hear one hit.
- Set the pitch with TUNE, then shape the drop with SWEEP and P DEC.
- Set the length with DECAY, the attack click with PUNCH, and add grit with DRIVE.
- Turn up RUMBLE for a low tail after each hit, and set its length with R DEC.
Controls
Pitch
- TUNE: the note the kick lands on (30-120 Hz). The V/OCT jack adds to it, so a sequencer can play the kick in key.
- SWEEP: how far above that note each hit starts (up to 5 octaves). Low = a soft thump, high = a laser-like zap.
- P DEC: how fast the pitch falls (4-250 ms).
Body
- DECAY: how long the kick rings (60 ms to 1.2 s).
- PUNCH: a short noise click at the start of each hit.
- TONE: a low-pass filter (300 Hz to 20 kHz). Fully up (the default) = open; turn down for a darker, rounder kick.
Dirt / Rumble
- DRIVE: saturation, up to 30 dB of push into soft clipping.
- RUMBLE: how loud the rumble tail is. At zero (the default) there is no rumble.
- R DEC: how long the rumble rings (150 ms to 1.5 s).
Out
- LEVEL: the output level of the kick and the rumble.
- ACCENT: how much the ACC jack changes the hit. 10 V at ACC = full hit, lower voltages = softer hits; the more ACCENT, the softer they get. With ACC unpatched, every hit is full.
- DUCK: how much the kick pushes the rumble down while it sounds. High = the rumble swells in after the kick; low = both sound together.
Lights and menu
- The lights over the knobs go from yellow to deep red as you turn them up. The lights under the jacks glow orange for positive voltage and blue for negative. The small light at the top flashes with each hit.
- Right-click menu: Trigger kick (audition) plays one hit.
Jacks
Inputs
- Trigger
- Accent 0 to 10 V
- V/OCT tune
Outputs
- Kick + rumble
- Rumble only
- Envelope (0 to 10 V) for ducking
N = 1, 2, 3 ... (one jack per track, channel or strip). Hover a jack in Rack for the same text.
Tips
- KICK carries the kick and the rumble together; RUMBLE sends the rumble alone, so you can treat the tail with its own filter, reverb or delay.
- Patch ENV (0-10 V, follows the kick's decay) into a VCA or sidechain input to duck pads or bass under the kick.
- Pairs well with Euclid (clock it from one of its channels), Snare/Hat on the same clock, and MIX Fire to bring it all together.
- Patch a sequencer's pitch into V/OCT to play a tuned kick line, like a booming 808-style bass.